Search found 4 matches

Go to advanced search

by hageir
Tue Apr 22, 2014 9:55 am
Forum: QuNexus Feature Wishlist
Topic: CV Transpose Request
Replies: 2
Views: 2971

Re: CV Transpose Request

Happy Easter!! If I switch the Pitch Scaling Mode to 1V/Oct (not intended for the Yamaha Hz/Volt system) I can indeed reach those lower notes! It's like the Hz/V system can't reach down to 0.250V (which is the first/lowest note in the Yamaha Hz/V standard but according to the manual it should be 0.1...
by hageir
Sat Apr 19, 2014 9:33 pm
Forum: QuNexus Feature Wishlist
Topic: CV Transpose Request
Replies: 2
Views: 2971

Re: CV Transpose Request

Still waiting for a reply on this, the CV outs must be able to go lower than this, right? So far none of the parameters have worked for "transposing" the CV down an octave, CV Trim Offset Gain They all have the same effect on the CV out = it goes "under" the possible range and be...
by hageir
Tue Apr 15, 2014 4:25 pm
Forum: QuNexus Feature Wishlist
Topic: CV Transpose Request
Replies: 2
Views: 2971

CV Transpose Request

I just got my Qunexus and wow, it feels like a futuristic controller :) I'm loving it! I'm using it to sequence/control my Yamaha CS-15 (Hz/V & S-Trig) and it works fine, except the CV output on the Qunexus is one octave higher than the Yamaha (the lowest octave on the Qunexus is one octave high...
by hageir
Tue Apr 15, 2014 4:20 pm
Forum: QuNexus Feature Wishlist
Topic: CV gate out on 2 or 3
Replies: 4
Views: 4086

Re: CV gate out on 2 or 3

. ok could u duplicate the gate cv port (for example with a splitter)? This is in fact possible. On the Kenton website there's a tip for controlling a synth with double inputs (like the Yamaha CS-15/CS-30) I had a Kenton Pro-4 once and I ran two pairs of outputs to the CS-15, then I found out about...

Go to advanced search

cron