Page 1 of 1

Can't program Softstep 1

Posted: Fri Oct 30, 2015 8:43 am
by Billowhead
Hello,

I just got a used SoftStep1 and it shows up just fine in my computer and I can monitor incoming midi and all that, but when I try to program anything from the editor the SS drops off and I don't receive any midi signal any longer (on any bank or scene). If I restore the firmware the SS shows up again and transmits data but any change made in the editor and sent to the SS kills its communication (and I have rescanned the computer and reconnected all midi devices and it does show up as listed, just no data).

Any idea what I'm doing wrong (as I assume its ignorance and not hardware but...)?

Thanks,

Kevin