Yes, the global sensitivity affects the expression pedal sensitivity, in an adverse way. Reset the sensitivity and don't change it.
Reset it and it didn't help.
How about not calibrating?
Will try that, but I don't expect it to help as the calibration curves are pretty subtle.
What does your calibration graph look like?
Close to a diagonal line, small hump in the middle, tried multiple calibration graphs, comes out a bit different each time, with all three pedals used. Different, but not radical.
Basic or Advanced Editor?
Hosted or Standalone?
What does your Modline look like?
Its a mod line in Nav pad control (I assume you could put it on any pedal, but since there isn't an expression pedal control assumed the nav pad was as good as any).
mode - none, value - 0, source - pedal, raw, gain - 1.00, offset - 0, table - linear, min - 0, max - 127, smooth - 0 (tried quite a few settings), delay - 0, message - cc
How are you monitoring the data?
a) watching data in settings/pedal
b) watching data in mod line in Nav settings
c) watching fader move in Live
Tried with three different pedals:
Moog - with chord it comes with through sofstep 1/4" to 1/8" adapter
Roland EV5 - with attached chord into sofstep adapter
Roland volume pedal - with dual 1/4" to 1/8" adapter
Tried all three pedals into a Logidy UMI3, all three work fine in the logidy.http://www.logidy.com/?pid=1
Will try tomorrow without calibrating the pedal, but don't think it will change much, based on all the fiddling I've done tonight.