So I've setup my two rotaries to act as 0-127 value knobs. The values are the same for both, and both function as intended when finger spinning in a clockwise direction. I'm utilizing the "direction" parameter in the editor. (mapped to Ableton sends or pan, etc on an entirely blank song template (no other mappings))
However, when I spin counter clockwise on the left encoder it jumps in value chunks of 30 or so without me travelling the same finger distance that I just travelled in a clockwise direction. IE: I finger spin a full 0-127 clockwise and the reflected value is 127, but when I spin counter clockwise just a fraction the Ableton value drops by almost 50%.
It is impossible to accurately lower the value. I have checked in the editor and I 100% do not have any double mapped values (IE the left and right rotaries are not sending the same messages).
Even more odd, I SOMETIMES map it to a different parameter and it works as intended.
Is this a hardware fault, an Ableton fault or what?
Last edited by Schmidi
on Sun Feb 15, 2015 7:03 am, edited 1 time in total.