Very brand new to the KMI world, pardon my ignorance. I'm a bit of a dinosaur so my knowledge of MIDI gear is pretty much limited to legacy MIDI hardware.
My use case:
QuNeo > USB MIDI interface > Mac > USB MIDI interface > Legacy 5-pin DIN MIDI FX processor
QuNeo > KMI MIDI Expander > Legacy 5-pin DIN MIDI FX processor
Rather than sending note information upon pad-strike, I would like to send Program Change messages to the MIDI FX processor. I've had various foot pedals that have done the job but I'm trying to downsize my gear and I was hoping I could replace a couple pieces of gear with the QuNeo and assumed using it to send MIDI Program Changes would be an easy task.
I see that I can have it send a Program Change upon preset change, but I was hoping to keep using the same preset on the QuNeo and use each pad to map to a specific Program Change and the touch faders/rotary controllers to do CC changes. I understand how to set up the CC stuff, but after reading the manual/scouring the web, I'm not seeing an easy way to set up the pads to send the Program Changes. Am I missing something? Is it possible?