Page 1 of 1
Tilt function on the Rotaries?
Posted: Thu Aug 17, 2017 11:46 am
Is it possible to create an update that implements a tilt function on the rotary sensors, similar to the implementation in the K-Mix, so that one could directly control a multi-point panner with the Quneo, or program a sequencer to do automations of this? Thanks!
Re: Tilt function on the Rotaries?
Posted: Fri Aug 18, 2017 10:09 am
I'm not sure what a 'tilt' function is in regards to a rotary control. Are you looking for angle (location) and radius?
The QuNeo rotaries are fundamentally different in their design from the rotaries on the K-Mix, so there is no option to include that functionality in future firmware update.