mod wheel tips with rotary quneo

Show off your QuNeo tricks here
alexblueshirt
Posts: 5
Joined: Wed Jun 08, 2016 12:13 pm

mod wheel tips with rotary quneo

Postby alexblueshirt » Thu Jun 09, 2016 1:50 pm

hello someone can help me ?

I try so set my quneo rotary to control the mod wheel of my synth
the mod wheel cc param is 1 for my synth...;where I have to set it with Quneo to control that with rotary ?
so, what i have to do to set the value of : note, pressure, location, direction, normal/toggle, Vell/cc output

thanks,
Alex
TheOtherSupport@KMI
Posts: 705
Joined: Fri Jan 31, 2014 5:31 pm

Re: mod wheel tips with rotary quneo

Postby TheOtherSupport@KMI » Thu Jun 09, 2016 2:42 pm

If you want the location on the rotary to control CC 1, you would put '1' into the box left of location.
alexblueshirt
Posts: 5
Joined: Wed Jun 08, 2016 12:13 pm

Re: mod wheel tips with rotary quneo

Postby alexblueshirt » Thu Jun 09, 2016 3:29 pm

thanks !!
and what I have to do for the mod wheel go back to intial value like a mod wheel with the rotary ?
TheOtherSupport@KMI
Posts: 705
Joined: Fri Jan 31, 2014 5:31 pm

Re: mod wheel tips with rotary quneo

Postby TheOtherSupport@KMI » Fri Jun 10, 2016 6:44 am

Mod wheels actually don't usually snap back to center (i think thats what you're talking about), that's how pitch bend wheels behave though.
The rotaries do not have an option for return values on release.
alexblueshirt
Posts: 5
Joined: Wed Jun 08, 2016 12:13 pm

Re: mod wheel tips with rotary quneo

Postby alexblueshirt » Fri Jun 10, 2016 8:46 am

sorry for my english, Yes i was talkin about that.
thank you for the reply
alexblueshirt
Posts: 5
Joined: Wed Jun 08, 2016 12:13 pm

Re: mod wheel tips with rotary quneo

Postby alexblueshirt » Fri Jun 10, 2016 8:48 am

is it the same for sliders ? the sliders can t go back to center when release.
no return value option for sliders ?
TheOtherSupport@KMI
Posts: 705
Joined: Fri Jan 31, 2014 5:31 pm

Re: mod wheel tips with rotary quneo

Postby TheOtherSupport@KMI » Fri Jun 10, 2016 9:32 am

Nope, only for the pads.

Return to “QuNeo Tips and Tricks”

Who is online

Users browsing this forum: No registered users and 1 guest

cron