Page 1 of 1

mod wheel tips with rotary quneo

Posted: Thu Jun 09, 2016 1:50 pm
by alexblueshirt
hello someone can help me ?

I try so set my quneo rotary to control the mod wheel of my synth
the mod wheel cc param is 1 for my synth...;where I have to set it with Quneo to control that with rotary ?
so, what i have to do to set the value of : note, pressure, location, direction, normal/toggle, Vell/cc output

thanks,
Alex

Re: mod wheel tips with rotary quneo

Posted: Thu Jun 09, 2016 2:42 pm
by TheOtherSupport@KMI
If you want the location on the rotary to control CC 1, you would put '1' into the box left of location.

Re: mod wheel tips with rotary quneo

Posted: Thu Jun 09, 2016 3:29 pm
by alexblueshirt
thanks !!
and what I have to do for the mod wheel go back to intial value like a mod wheel with the rotary ?

Re: mod wheel tips with rotary quneo

Posted: Fri Jun 10, 2016 6:44 am
by TheOtherSupport@KMI
Mod wheels actually don't usually snap back to center (i think thats what you're talking about), that's how pitch bend wheels behave though.
The rotaries do not have an option for return values on release.

Re: mod wheel tips with rotary quneo

Posted: Fri Jun 10, 2016 8:46 am
by alexblueshirt
sorry for my english, Yes i was talkin about that.
thank you for the reply

Re: mod wheel tips with rotary quneo

Posted: Fri Jun 10, 2016 8:48 am
by alexblueshirt
is it the same for sliders ? the sliders can t go back to center when release.
no return value option for sliders ?

Re: mod wheel tips with rotary quneo

Posted: Fri Jun 10, 2016 9:32 am
by TheOtherSupport@KMI
Nope, only for the pads.