Page 1 of 1

QuNeo Max/MSP Dev Kit Available Now

Posted: Wed Apr 03, 2013 5:29 pm
by TheSupport@KMI

Re: QuNeo Max/MSP Dev Kit Available Now

Posted: Fri May 09, 2014 10:58 pm
by dothque
Hello,

I get wrong functioning with this Dev Kit.
The sliders info is showing in the Pads.
the example with @ pad 2 showing the sliders as the X/Ys values.

I guess that there is a mismatch beŚween the notes .
any suggestions?

Re: QuNeo Max/MSP Dev Kit Available Now

Posted: Mon May 12, 2014 2:56 pm
by emmett@KMI
Are you putting your QuNeo into tethered mode?

Re: QuNeo Max/MSP Dev Kit Available Now

Posted: Tue May 13, 2014 6:10 am
by dothque
I tried to use that option but still no luck.

In the Patch i see that the Sliders should be on Channel 3 and the buttons on 4.
in the Quneo editors all in CH.1

the Vertical Sliders CC are 3 - 6.
this explains why the move the Pad 2 X Y values.
setting Pad 2 X and Y to 4 gives a better result but still need to fine tune it.

I will play around again with the tethered mode.
Any steps needs to be taken prior to that?

Thanks for your reply!

Re: QuNeo Max/MSP Dev Kit Available Now

Posted: Tue May 13, 2014 12:03 pm
by emmett@KMI
It sounds like you're not properly in tethered mode. This dev kit is made to handle the raw data so you should be seeing 16 CCs per slider.

Re: QuNeo Max/MSP Dev Kit Available Now

Posted: Wed May 14, 2014 1:36 am
by dothque
Hi,
The guy that uploaded the Patch told me the exact same thing.
So I guess that is the solution.

Thanks for advising.

Re: QuNeo Max/MSP Dev Kit Available Now

Posted: Wed May 21, 2014 4:14 am
by dothque
Hi,
Today I have finally got it, in tethered mode the pads locations are inverted.
so pad number two becomes pad number 14.

now I wonder if it is possible to turn on the LEDS as well?

Thanks for the tips :)