max/msp

[mattebass]

Hello,
I'd like to know if there's a max sdk for QuNexus as like as for other products
thanks

Matteo

[TheOtherSupport@KMI]

There isn't an SDK, but there is a way that you can output the raw sensor data. It requires sending a few sysex commands, but it's not hard to set up. Let me know if you're interested and I'll throw a little patch together to get you started.

[mattebass]

Thanks, It would be great

[TheOtherSupport@KMI]

I've attached a simple patch, just select QuNexus port 1 from the menu, and use the toggle to switch between normal and tethered(raw output).

Let me know if you have any more questions!

Edit: Whoops! needed to zip it before the forum would accept the attachment.

[mattebass]

I'm sorry, but I can't find the attachment

[TheOtherSupport@KMI]

Corrected.

[mattebass]

thank you very much

[3rdtry]

I successfully see some CC messages with factory preset D, but no change when i toggle between tethered and normal. What did I do wrong?
Is there any way of debugging? should there come back a sysex message or should any led blink?
maybe the firmware changed? could I roll back than?


I'd really love to have this.
I bought the qunexus for absolute tilt values in the first place...
if not a solution, a diagnosis wold be appreciated too, just so I don't throw more time at this problem

[mehak]

It would be possible to change the LEDs wrapping (it actually makes programming the LED's a pain, especially because if you shift up one octave, the external control will be lighting the wrong octave) in a firmware update.
___________________
Usman