Page 1 of 1

4.4.1 Surround buss?

Posted: Thu Aug 09, 2018 11:48 pm
by Pongoid
Might it be possible in the next firmware update to add another surround routing that essentially adds a Z axis to the panning buss so that outs 1-4 are low or Z-1 and 5-8 are the same corresponding corners as 1-4 but Z+1 thus simulating a cube, maybe employing what would be aux master volumes 1-3 as the Z value for at least the first three busses?

Re: 4.4.1 Surround buss?

Posted: Fri Aug 10, 2018 6:12 am
by TheOtherSupport@KMI
That isn't really a standard surround setup, and usually height is pretty hard to perceive as listeners unless the speakers are quite far apart. Not to mention the issues that come with implementing that in a GUI.
I can certainly add it to the request list though.