I have been trying out a new Moog Ep3 pedal today and after doing some programming experiments, when I tried to send some changes to my SS2 (in standalone mode) I got a frozen LOAD message on the SS2 LED and the red LEDS for keys 1 and 0 stay lit. The editor also crashes at this point. Tried this a few times, same result. Tried rebooting the computer, disconnected the expression pedal, no joy.
Any ideas? Reinstall firmware?
SS2 firmware 91, editor ver 2.02.
EDIT: info on the programming I was doing right before the problem arose -
I have 2 presets I am using in standalone mode. I created a modline for the expression pedal with a different CC, one for each preset. When I tried this out, one of my key leds starting to blink when the pedal was fully depressed. This was no good for me, so I went back to the editor and disabled one of the pedal modlines and when I tried to update the Softstep, I got the above mentioned crash.
OK Had to update the firmware because nav pad wouldn't change presets when I arrived at rehearsal. Opened preset 1 -sent to SS2 no probs. relief. Opened preset 2 and got the crash on trying to send to SS.
Current conclusion: conflict in modlines in that preset causes crash. Will delete it and rewrite and take it from there.