Solutions for midi routing

MoDrum
Posts: 1
Joined: Thu Aug 09, 2018 1:43 pm

Solutions for midi routing

Postby MoDrum » Thu Aug 09, 2018 11:49 pm

Hello everyone,

I have a question about routing midi signals in the BopPad:

How can I separate the 4 different pads? In the specific, when controlling a gate effect for example, I would like to map it so that I can control the effect with 3 pads and not with the 4th, in order to use only with a VST.

I hope I made it explaining what my problem is.

Any suggestion?
TheOtherSupport@KMI
Posts: 729
Joined: Fri Jan 31, 2014 5:31 pm

Re: Solutions for midi routing

Postby TheOtherSupport@KMI » Fri Aug 10, 2018 6:14 am

That's what MIDI channels are used for. Set three of the quadrants to one MIDI channel and the fourth to another. Or set 3 to all send the same CC to control the gate, and the fourth not to send that CC. There's a lot of different ways to separate MIDI messages.

Return to “BopPad General Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest