I’m not familiar with the Counter, since I have been operating solely in Standalone Mode to control two Eventide H9s and the manual says the Counter only works in Hosted Mode. Is there a way to cycle and wrap values in a range in Standalone mode, too?
I’d like to use separate SS2 keys to:
- cycle through the Iridium’s three Amps
- cycle through the Iridium’s nine Cab IRs. (I’m not sure how this is going to work in practice, since the Iridium breaks these IR’s into subsets of three for each amp. I might need to separate these into one set of three, per amp?)
- cycle through the Iridium’s three Room reverb sizes
SOURCE: Y Increment. –> GAIN: 1.00 –> OFFSET: 0 –> TABLE: Linear.–> MIN: 0 MAX: 8 SMOOTH: 0 –> MSSGE TYPE: CC –> CC# 20 –> CH: 3 –> OUTPUT PORT: SS Expander
Here are the IRIDIUM MIDI SPECS I’m working with:
PARAMETERS.....CC#........RANGE.......NOTES
Amp..................19..........1-3............Round. Chime. Punch.
Cab...................20..........0-2............(Round a, b, c)
.........................20..........3-5............(Chime a, b, c)
.........................20..........6-8............(Punch a, b, c)
Thanks for any assistance you can lend.