Hi,
I'm using my QuNexus on iPad. Instead of sending MIDI note-off messages (like my Korg NanoKey2 does), the QuNexus sends "note-on with zero velocity".
I wonder why this was chosen. Strangely, when I use MIDI-OX to look at the messages that the QuNexus sends when connected to PC via USB MIDI, it reports that the QuNexus is sending real note-off messages, I don't understand why it would be different.
I know that encoding note-offs in this way is a "valid" choice. However, it has caused me a whole load of problems with various iPad apps... so much so that I've had to ditch the QuNexus as my iPad's constant companion. A couple of examples of apps that don't work with the QuNexus are Thesys and MIDI Pattern Sequencer. They just don't work without real note-offs. No problems when I switch to the NanoKey2. I have a hunch that it causes problems with Cubasis MIDI routing too, but I've not been able to establish that for sure.
I'd really much rather my QuNexus sent real note-offs. Could this be changed in a firmware update? If there's actually a good reason why this was chosen then could it be configurable?
Appreciate any reply, thanks, David