Page 1 of 1

Solutions for midi routing

Posted: Thu Aug 09, 2018 11:49 pm
by MoDrum
Hello everyone,

I have a question about routing midi signals in the BopPad:

How can I separate the 4 different pads? In the specific, when controlling a gate effect for example, I would like to map it so that I can control the effect with 3 pads and not with the 4th, in order to use only with a VST.

I hope I made it explaining what my problem is.

Any suggestion?

Re: Solutions for midi routing

Posted: Fri Aug 10, 2018 6:14 am
by TheOtherSupport@KMI
That's what MIDI channels are used for. Set three of the quadrants to one MIDI channel and the fourth to another. Or set 3 to all send the same CC to control the gate, and the fourth not to send that CC. There's a lot of different ways to separate MIDI messages.