On one quadrant if I set pressure to send on CC 1 and radius to send on CC 2 when I enable MIDI mapping mode in Ableton it only recognizes one of them. I've been changing the preset in the BopPad editor to only send one of the parameters, mapping it in Ableton and then changing the preset to send the other and mapping it in Ableton and then enabling both parameters in the preset and then they'll both track in Ableton. However this feels really clunky.
On my QuNeo I hold down the mode button for a few seconds and different CC values on a single pad are sent to mapping depending on where on the pad I press until I press the mode button again. Is there a similar function for the BopPad? Thanks!!